Last updated
Was this helpful?
Below are all commands that operate on lines/polylines.
Create room from selected closed polylines. Set the room display name, and adjust the Floor Height and Floor to Ceiling Height if needed. By default, the command uses the heights of the current active story.
Room Name
Text to set the name of the generated room.
Use Current Story Height
Select to use the current story height for the newly created room. Unselect this option to be able to have specify the room height and floor elevation explicitly
Room Height
Height of the room.
Room Elevation
Elevation of the room.
Explode a polyline into several line segments.
Join several segments into one or more polylines.
Offset the selected lines and/or polylines by a specified distance.
Offset Distance
The distance that the selected line/polyline will be offset. This can be either positive or negative and positive values will be interpreted as offsetting outwards or 'to the right' while negative numbers will be offset inwards or to 'to the left'
Perimeter Polygons
Select to have the output be a series of closed perimeter polygons instead of a single offset line or polyline. Perimeter polygons can be used to split rooms into core and perimeter
Remove colinear vertices from a polyline.
Tolerance
The maximum distance between a polyline vertex and the line drawn between neighboring vertices below which it is considered colinear
Last updated
Was this helpful?
Was this helpful?